DME Tuning BMW M5 2014 Comp ECU Tune
DME Tuning ECU calibration for BMW M5 2014 Comp. Select the stage that matches your vehicle and installed hardware.
Tuning stages
| Calibration | Horsepower (HP) | Torque (TQ) | Hardware / configuration |
|---|---|---|---|
| Factory | 575 | 502 | Factory calibration |
| Stage 1 | 720 | 700 | Stock exhaust |
| Stage 2 | 750 | 740 | Downpipes Required |
| Stage 3 | 775 | 760 | E30 Fuel |
Performance figures are as listed by DME Tuning. Torque follows the source TQ label.
Listed calibration features
- Fuel-octane-specific calibration.
- Downpipe-related check-engine-light calibration, listed by DME for off-road use only.
- Speed-limiter calibration where supported.
- Cold-start settings.
- Exhaust burble adjustment where supported.
- Original ECU settings are retained to support a return to stock.
Programming and requirements
- Remote OBD flashing uses a supplied cable and TeamViewer. DME lists a Windows 7 or newer laptop for the session.
- Shipping for the OBD cable is additional.
- DME recommends spark plugs one heat range colder.
- For Stage 2 and higher, DME specifies a 0.020-inch spark-plug gap.
- DME recommends replacing spark plugs and primary oxygen sensors every 15,000 miles.
The vehicle VIN is required to arrange the correct calibration.