DME Tuning BMW X3 xDrive 28i 2017 ECU Tune
DME Tuning ECU calibration for BMW X3 xDrive 28i 2017. Select the stage that matches your vehicle and installed hardware.
Tuning stages
| Calibration | Horsepower (HP) | Torque (TQ) | Hardware / configuration |
|---|---|---|---|
| Factory | 240 | 255 | Factory calibration |
| Stage 1 | 300 | 320 | Stock exhaust |
| Stage 2 | 320 | 340 | Downpipes Required |
Performance figures are as listed by DME Tuning. Torque follows the source TQ label.
Listed calibration features
- Fuel-octane-specific calibration.
- Downpipe-related check-engine-light calibration, listed by DME for off-road use only.
- Speed-limiter calibration where supported.
- Cold-start settings.
- Exhaust burble adjustment where supported.
- Original ECU settings are retained to support a return to stock.
Programming and requirements
- Remote OBD flashing uses a supplied cable and TeamViewer. DME lists a Windows 7 or newer laptop for the session.
- Shipping for the OBD cable is additional.
- DME recommends spark plugs one heat range colder.
- DME recommends replacing spark plugs and primary oxygen sensors every 20,000 miles.
The vehicle VIN is required to arrange the correct calibration.